| Plastic repair of common sense | |||
| Symptom | reason | ||
| 1 | No glue | 1，no pressure | Check pipe connect, and add the pressure. |
| 2，no glue | 1，did not put in glue | ||
| 2, pipe jammed | |||
| 3，gun jammed, | |||
| 4, the pipe headache jammed | |||
| sundries closed | open | ||
| 5， gun no move | 1, clean 2，change the gasket | ||
| 6， no gas input | change Solenoid valve | ||
| 7，head angle wrong | repair | ||
| 2 | glue too much or too less | 1，pressure not right | adjust pressure |
| 2，swicth not correct | change the gun head | ||
| 3， glue too thin or too thick | correct the glue thickness | ||
| 4， gun head size not correct | change | ||
| 5，time too long or too short | adjust panel | ||
| 6，glue out not correct time | adjust panel | ||
| 7，basket gas leak | correct it basket. | ||
| 3 | air leak | 1pipe breaken | change |
| 2Solenoid valve breaken | change | ||
| 3gasket breaken, not correct place | move or change | ||
| connect breaken | change | ||
| 4 | glue leak | 1，gasket breaken | change it |
| 2，pressure not enough | check pipe jammed | ||
| 3，gun inside has sundries | clean | ||
| glue pipe has gas in. | make the gas out. | ||
| 5 | turner no move | 1， link cutted | change link |
| 2， turner glued fixed | clean the turner | ||
| 6 | glue not on correct place | 1，the headche is not correct | change head and correct it |
| not at same concentric | fix the turner | ||
| 3，T yoke center hole not correct | 1 adjust the turner center 2 adjust T-yoke OD fix | ||
| 7 | no action | 1，no power | 1，on it 2，connect line, |
| 2，Foot Swicth breaken | change | ||
| 3, no pressure. | check pipe | ||
| chang | |||
| 1， AB glue must meet correct inverse proportion , need check every 15min's | |||
| 3，spider glue can add a little toluene | |||
| 4， | |||
| 5，toluene can clean gun, but cannot save gun , the machine plastic gasket cannot meet toluene long time. | |||
| 6，gun need clean every day, need separate the gun if no use it more than 12hour and save in laky ， need heck the gasket every week, change it if has damage. | |||
| 7，add oil at movement parts | |||
| work step: 1 check power and presure, 2， move the gun too enough place, ( if go down will not damage speaker 3，tight all screw 4， notice the gas basket safety ，5，pressure cannot over 6kgs, | |||
