Speaker Accessories Speaker Spider Leads There are many places in the speaker that need to be soldered when making the speakers. So how do you know how to solder? Let's introduce the correct soldering method for the speaker accessories.
Speaker accessories speaker spider with lead wire correct welding method:
1. The lead wire should be 1 to 2 mm above the upper edge of the voice coil bobbin and bent downward (note that the curvature is not too small), soldered to the braided wire solder joint on the lower part of the cone, and the lead wire is adhered with an adhesive.
2. After bonding the voice coil bobbin and the paper cone, the lead wire is welded to the braided solder joint on the lower part of the paper cone, and the lead wire is bonded to the paper cone by a soft adhesive such as Lidobao. , so that the lead wire and the cone are firmly bonded.
3. The thin copper braided wire and the voice coil lead wire are welded together, and bent from the upper end of the skeleton to the solder joint at the lower end of the paper cone, and coated with a soft adhesive.
